Setting Up the Television
21
Turning Off the Television
•
Press the power button on the television or on the remote control.
The internal fans continue to run for a short time during the cool-down period. Even though the television is off, it
continues to use a small amount of power.
If you turn on the television again during the cool-down period, the television might not turn on as quickly as usual.
CAUTION:
•
Do not disconnect power until the television has cooled and the fan stops running—up to three minutes after
turning it off. Otherwise, you might shorten the life of the lamp.
•
If power is removed from the television, wait more than two minutes before attempting to turn on the
television. Otherwise, you might shorten the life of the lamp.
Completing the Basic Setup
Finding Your Available Channels
After you connect your cable and/or antenna, you are ready to find the available channels. These are the channels you
can receive on the television’s tuner using the
Ch+
and
Ch-
buttons.
If you have an antenna connected to the antenna input:
1.
On the remote control, press
Source
.
Press the arrow buttons to select
Antenna
and press OK
.
2.
Press
Menu
. Press the left or right arrow
buttons to select the
Source
menu.
3.
Press the up or down arrow buttons to
select
Channel setup
and press OK.
Press the up or down arrow to select
Auto search
. Press OK.
4.
Wait for the television to scan all
available channels.
If you have cable service connected to the cable input:
1.
On the remote control, press
Source
. Press the arrow buttons to select
Cable
and press OK.
2.
Press
Menu
. Press the left or right arrow buttons to select the
Source
menu.
3.
Press the up or down arrow buttons to select
Channel setup
and press OK. Press the up or down
arrow to select
Auto search
. Press OK.
4.
Wait for the television to scan all available channels.
After all channels are found, you can manually add or remove channels from the list. See “Adding or Deleting a
Channel” on page 36.
TIP:
If you have a cable box or satellite receiver, you must set up that device before you can view channels from
that source. The television tuner receives channels only from the antenna and cable inputs.
NOTE:
The following steps can take from one minute to more than 30 minutes, depending on the available
channels in your area.
Cable
Antenna
HDMI 1
HDMI 2
Component 1
Component 2
Video 1
Video 2
Video 3
Photo Viewer
Summary of Contents for ID5220N
