HP High-Performance Secure Hard Disk, Setup Manual

Page: 13 / 54

◦
HP High-Performance Secure Hard Disk (J8018A).
This HP Secure Hard Disk (J8018A) includes pre-mounted disk rails that are typically required
for installation in the formatter door.
●
The latest version of the printer/MFP firmware.
If you are installing an HP Secure Hard Disk in an existing printer/MFP, verify that it contains the
latest firmware. For firmware upgrade instructions, see the setup or use guides provided with your
printer/MFP.
NOTE: If you must upgrade the printer/MFP firmware, do this now before you install the
HP Secure Hard Disk.
After upgrading the firmware, and restarting the printer/MFP, you can verify the firmware is installed
correctly by using the following procedure:
◦
Start a supported Web browser and enter the IP address or host name of the printer/MFP.
◦ Select the Settings tab and then select Security .
◦
In the Hard Drive and Mass Storage Security Settings section, select Configure .
Because the current hard disk cannot be encrypted, you should see information similar to the
following displayed in the
Hard Drive Status section:
Hard Disk: Internal (Not encryptable)
Serial Number: ABCDE1234567890abcde
Drive Status: Enabled
Encryption Status: Not supported
The Hard Disk , Drive Status , and Encryption Status fields indicate that the firmware is
capable of supporting the HP Secure Hard Disk.
ENWW What you need for installation 7