65
HIM/MIM failures
Symptom
When a HIM/MIM is hot swapped, the output from the configuration terminal shows that the HIM/MIM
is faulty or the router cannot recognize the HIM/MIM.
%Jun 14 11:12:36:037 2012 HPE DRVICOUT/1/DrvIcOutStr: -Slot=4;
Card in Slot 4 Sublot 1 can not be recognized !
Solution
To resolve the problem:
1.
Verify that the HIM/MIM is firmly seated.
2.
Verify that the HIM/MIM is correctly inserted into a FIP-210/FIP-600 module. A FIP-110 module
does not support HIMs.
3.
Verify that the HIM/MIM connector pins of the FIP module are not bent.
4.
If the problem persists, contact Hewlett Packard Enterprise Support.
Configuration system problems
If the configuration environment setup is correct, the configuration terminal displays boot information
when the router is powered on. If the setup is incorrect, the configuration terminal displays nothing or
garbled text.
No terminal display
Symptom
The configuration terminal displays nothing when the router is powered on.
Solution
To resolve the problem:
1.
Verify that the power supply system is operating correctly and the console cable is correctly
connected.
2.
Verify that the console cable is connected to a correct serial port. (The serial port in use must be
the one set on the terminal.)
3.
Verify that the console terminal settings are as follows:
{
Bits per second—9,600.
{
Data bits—8.
{
Parity—None.
{
Stop bits—1.
{
Flow control—None.
{
Terminal Emulation—VT100.
4.
Verify that the console cable is not faulty.
5.
If the problem persists, contact Hewlett Packard Enterprise Support.
Garbled terminal display
Symptom
Terminal display is garbled.