33
Figure 37 Connecting a fiber cable
5.
Examine the LINK LED after connection.
{
If the LED is on, the optical fiber link is present.
{
If the LED is off, no link is present. This might be because the TX and Rx port of the optical
fiber are not connected correctly. In this case, connect the optical fiber again.
Connecting a T3 cable
Overview
As a best practice, install a special lightning protector at the input end of the T3 cables to protect
them against lightning strikes more efficiently when they are routed outdoors.
You can use a T3 interface cable to connect the MIM-1T3-V2 modules.
Figure 38 T3 cable
Connecting a T3 cable
1.
Connect the SMB connector of a T3 cable to the Tx port on the interface module and the other
end to the Rx port on the device to be connected.
2.
Connect the SMB connector of another T3 cable to the Rx port of interface module and the
other end to the Tx port on the device to be connected.
1
2
3
4