HP E3494A, Installation And Service Manual

Page: 95 / 108

M>? pv
pv <options> <count> - Execute the performance verification diagnostics.
pv - display pv warning message
pv -l - list available pv tests only (do not execute)
pv -d - execute emulator subsystem tests only
pv -t <[-y]> - select system test number <x> or range <x-y> only
pv -t * - select all system tests
pv -d -t - select emulation subsystem test only
pv -v <verbose> - set verbose level; valid levels: 0-9
pv -f - force tests to execute (HP internal use only)
pv -n - do not initialize system (HP internal use only)
pv <count> - execute diagnostics <count> number of times,
<count> of 0 repeats until keyboard break
--- SYSTEM SETUP ---
o Connect a coaxial cable between the BREAK IN and TRIGGER OUT BNCs.
o Replace the target cable with the SELFTEST LOOPBACK connector.
o To execute the LAN Feedback tests, disconnect the LAN BNC connector
from the network and terminate with two 50 ohm terminators on a tee.
(Run pv from the RS232 Port with LAN disabled)
*** WARNING *** This command performs a system initialization after
all pv execution is completed.
M>
Examples:
To execute both tests one time:
pv 1
To execute test 2 with maximum debug output repeatedly until a ^C is
entered:
pv -t2 -v9 0
To execute tests 3, 4, and 5 only for 2 cycles:
pv -t3-5 2
Solving Problems
To execute the built-in performance verification test
87