Hardware options installation 26
Installing DIMMs
CAUTION:
To avoid damage to the hard drives, memory, and other system components, the
air baffle, drive blanks, and access panel must be installed when the server is powered up.
1.
Power down the server (on page
15
).
2.
Do one of the following:
o
Unlock and remove the bezel.
o
Extend the server from the rack.
3.
Remove the access panel (on page
16
).
4.
Remove the air baffle (on page
16
).
For more information, see the server installation sheet on the HP website
(
http://www.hp.com/go/bizsupport
).
5.
Open the DIMM slot latches.
6.
Install the DIMM.
7.
Install the air baffle.
8.
Install the access panel.
9.
Do one of the following:
o
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
If you are installing DIMMs in lock-step configuration, configure this mode in RBSU ("
HP ROM-Based
Setup Utility
" on page
52
).
For more information about LEDs and troubleshooting failed DIMMs, see the server installation sheet on
the HP website (
http://www.hp.com/go/bizsupport
).
Hard drive options
The server provides non-hot-plug capability through an embedded SATA controller. To obtain hot-plug
capability, install an optional controller and hot-plug cable option kit.
Summary of Contents for DL100 - ProLiant G2 320GB File Print Appliance
