S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
20
Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 5.2(2)
OL-25090-02
Downgrading Your Cisco MDS SAN-OS Software Image
•
You cannot nondisruptively downgrade from NX-OS Release 5.2(2) to NX-OS Release 5.0(x) if you
installed NX-OS Release 5.2(2) on an MDS 9509 or MDS 9506 switch and you installed a
Generation 4 module in the switch and performed a full switch reload. The reason for this restriction
is the change in fabric mode that occurs following the switch reload with the Generation 4 hardware
installed. The downgrade will be disruptive, even if you remove the Generation 4 module prior to
starting the downgrade.
If you do not install Generation 4 hardware or perform a full switch reload following the installation
of NX-OS Release 5.2(2) on an MDS 9509 or MDS 9506 switch, then you can nondisruptively
downgrade to NX-OS Release 5.0(x).
•
We recommend that you delete any SPAN configuration, Fibre Channel tunnel, or tunnel-ID map
configuration from your switch before you downgrade from NX-OS Release 5.2(2) to a lower
version. If any SPAN session, SPAN destination, SPAN target, or Fibre Channel tunnel interface is
configured, the installer should detect it and prompt you to delete these configurations.
To gather information about SPAN sessions and delete them, use the following commands in this
order:
–
show incompatibility systems bootflash:
image_name
to display any incompatible
configurations
–
show span session
to check the current configuration for a SPAN session
–
no span session
session-number
to delete a SPAN session
–
show running-config | include fc-tunnel
to check the current Fibre Channel tunnel
configuration
–
no interface fc-tunne
l
y
to delete a Fibre Channel tunnel on the switch that is the source for the
Fibre Channel tunnel
–
show interface brief | include SD
to check the current configuration for a SPAN destination
port configuration
–
show interface brief | include ST
to check the current configuration for a SPAN target port
configuration
–
no fc-tunnel tunnel-map
z
interface
x/y
to remove an Fibre Channel tunnel map
–
no switchport mode sd
to negate the SPAN destination port mode for the SPAN destination port
–
no switchport mode st
to negate the SPAN target port mode for the SPAN target port
General Downgrading Guidelines
Follow these general guidelines before you perform a a software downgrade:
•
Issue the system
no acl-adjacency-sharing
execute command to disable ACL adjacency usage on
Generation 2 and Generation 1 modules. If this command fails, reduce the number of zones, IVR
zones, TE ports, or a combination of these in the system and issue the command again.
•
Disable all features not supported by the downgrade release. Use the
show incompatibility system
downgrade-image
command to determine what you need to disable.
•
Use the
show install all impact
downgrade-image
command to determine if your downgrade will
be nondisruptive.
•
Be aware that some features impact whether a downgrade is disruptive or nondisruptive:
–
FCoE:
Fibre Channel over Ethernet requires Cisco NX-OS Release 5.2(x). A downgrade from
Release 5.2(x) disrupts and stops all FCoE traffic.
