Setup 19
Interconnect device mapping
To support network connections for specific signals, install an interconnect module in the bay
corresponding to the embedded NIC or mezzanine signals.
Server blade signal Interconnect bay
Interconnect bay labels
NIC 1 (Embedded)
1
NIC 2 (Embedded)
2
NIC 3 (Embedded)
1
NIC 4 (Embedded)
2
Mezzanine 1
3 and 4
Mezzanine 2
5 and 6
7 and 8
Mezzanine 3
7 and 8
5 and 6
For detailed port mapping information, see the HP BladeSystem enclosure installation poster or the
HP BladeSystem enclosure setup and installation guide on the HP website
(
http://www.hp.com/go/bladesystem/documentation
).
Installing a server blade
The HP BladeSystem c7000 Enclosure ships with four device bay shelves to support half-height devices.
To install a full-height device, remove the device bay shelf and the corresponding blanks.
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server blade
or the enclosure unless all hard drive and device bays are populated with either a component
or a blank.
Installation is shown in the HP BladeSystem c7000 Enclosure.
