HP AA-RSB6B-TE, Installation Manual

Page: 41 / 104

Installing the SAN Switch 2/8
41 hp StorageWorks SAN Switch 2/8 Installation Guide
I
Figure 10: Installing the rubber washers
b. Insert the alignment pins attached to the outer rail front flange into the
center opening in the rack.
c. Install one M5 Torx screw in the upper hole location of the right rail.
Then, install one M5 Torx screw in the lower location of the left rail. See
Figure 11 .
Note: Do not install the upper left and lower right screws until later.
1
Rubber washer (1 of 2)
2
Rear rail tray bracket (1 of 2)
[1] Select this graphic frame.
[2] Select
File.
[3] Select Import.
[4] Select File.
[5] Choose the appropriate graphic file name.
[6] Make sure you’ve checked the
Copy Into Document.
[7] Select Import. Position the illustration as required.
Delete this set of instructions
[8] Adjust the size of the outer graphic frame as required.
1
2
SHR-2559A