HP 8/20q, Cli Manual

Page: 206 / 332

206 Command reference
e
set config switch
Description Sets the switch configuration parameters. The changes you make with this command are not retained
when you reset or power-cycle the switch unless you save them using the
config save
command.
Authority Admin session and a Config Edit session
Syntax
set config switch
This command initiates an editing session in which to change switch configuration settings. The
system displays each parameter one line at a time and prompts you for a value. For each parameter,
enter a new value or press Enter to accept the current value shown in brackets. Table 37 describes
the switch configuration parameters.
Table 37 Switch configuration parameters
Parameter Description
AdminState
Switch administrative state.
•
Online
—Activates and prepares the ports to send data. This is
the default.
•
Offline
—Prevents the ports from receiving signal and accepting
a device login.
•
Diagnostics
—Prepares the ports for testing and prevents the
ports from accepting a device login.
•
Down
—Disables the ports by removing power from the port lasers.
BroadcastEnabled
Broadcast. Enables (
True
) or disables (
False
) forwarding of
broadcast frames. The default is
True
.
InbandEnabled
Inband management. Enables (
True
) or disables (
False
) the ability
to manage the switch over an ISL. The default is
True
.
FDMIEnabled
Fabric Device Monitoring Interface (FDMI). Enables (
True
) or disables
(
False
) the monitoring of target and initiator device information. The
default is
True
.
FDMIEntries
The number of device entries to maintain in the FDMI database. Enter
a number from 0–1,000. The default is
1000
.
DefaultDomainID
Default domain ID. The default is
1
.
DomainIDLock
Prevents (
True
) or allows (
False
) dynamic reassignment of the
domain ID. The default is
False
.
SymbolicName
Descriptive name for the switch. The name can be up to 32 characters
excluding #, semicolon (;), and comma (,). The default is
8/20q FC
Switch
.
R_A_TOV
Resource Allocation Timeout Value. The number of milliseconds the
switch waits to allow two ports to allocate enough resources to
establish a link. The default is
10000
.
E_D_TOV
Error Detect Timeout Value. The number of milliseconds a port is to
wait for errors to clear. The default is
2000
.
PrincipalPriority
The priority used in the FC-SW-2 principal switch selection algorithm.
1
is high,
255
is low. The default is
254
.
ConfigDescription
Switch configuration description. The configuration description can be
up to 32 characters excluding #, semicolon (;), and comma (,). The
default is
Config Default
.