HP 2520-24, Configuration Manual

Page: 100 / 110

4-14
IPv6 Diagnostic and Troubleshooting
Debug/Syslog for IPv6
Displaying a Debug/Syslog for Configuration
Use the show debug command to display the currently configured settings for:
■ Debug message types and Event Log message filters (severity level and
system module) sent to debug destinations
■
IPv4/IPv6 debug destinations (Syslog servers or CLI session) and Syslog
server facility to be used
Figure shows an example of
show debug
command output that displays a
configured IPv6 Syslog server.
Syslog Configuration to Receive Event Log Messages at Specified System Module
and Severity Levels on an IPv6 Syslog Server
HP Switch(config)# show debug
Debug Logging
Destination: None
Enabled debug types:
None are enabled
HP Switch(config)# logging fe80:215:60ff:fe7a:adc0
HP Switch(config)# write memory
HP Switch(config)# show debug
Debug Logging
Destination:
Logging --
fe80:215:60ff:fe7a:adc0
Facility=user
Severity=debug
System module=all-pass
Enabled debug types:
event
Displays the default debug
configuration when no Syslog
server IP addresses or debug
types are configured.
When you configure a Syslog
IPv6 address with the
logging
command, by default, the
switch enables debug
messaging to the Syslog
address and the
user facility on
the Syslog server, and sends
Event Log messages of all
severity levels from all system
modules.