HP 2520-24, Configuration Manual

Page: 30 / 110

1-18
IPv6 Addressing Configuration
View the Current IPv6 Addressing Configuration
For example, figure 1-1 shows the output on a switch having IPv6 enabled on
one VLAN.
Address Origin:
■
Autoconfig:
The address was configured using stateless
address autoconfiguration (SLAAC). In this case, the
device identifier for global unicast addresses copied from
the current link-local unicast address.
■
DHCP:
The address was assigned by a DHCPv6 server. Note
that addresses having a DHCP origin are listed with a 128-
bit prefix length.
■
Manual:
The address was statically configured on the
VLAN.
■
IPv6 Address/Prefix Length:
Lists each IPv6 address and
prefix length configured on the indicated VLAN.
Address Status:
■
Tentative:
DAD has not yet confirmed the address as
unique, and is not usable for sending and receiving traffic.
■
Preferred:
The address has been confirmed as unique by
DAD, and usable for sending and receiving traffic. The
Expiry time shown for this address by the
show ipv6 vlan <
vid >
command output is the preferred lifetime assigned to
the address. (Refer to “Address Lifetimes” on page xxx.)
■
Deprecated:
The preferred lifetime for the address has been
exceeded, but there is time remaining in the valid lifetime.
■
Duplicate:
Indicates a statically configured IPv6 address
that is a duplicate of another IPv6 address that already
exists on another device belonging to the same VLAN
interface. A duplicate address is not used.