HP 2520-24, Configuration Manual

Page: 49 / 110

2-7
IPv6 Management Features
IPv6 Telnet Operation
Enabling or Disabling Inbound Telnet Access
For example, to disable IPv4 and IPv6 Telnet access to the switch, you would
use this command:
Switch(config)# no telnet-server
Viewing the Current Inbound Telnet Configuration
Figure 2-5. Show Console Output Showing Default Console Configuration
Syntax: [ no ] telnet-server [listen <oobm | data | both>]
This command is used at the global config level to enable (the
default) or disable all (IPv4 and IPv6) inbound Telnet access
to the switch.
The
no
form of the command disables inbound telnet.
The
listen
parameter is available only on switches that have a
separate out-of-band management port. Values for this param-
eter are:
■
oobm — inbound Telnet access is enabled only on the out-
of-band management port.
■
data
— inbound Telnet access is enabled only on the data
ports.
■
both — inbound Telnet access is enabled on both the out-of-
band management port and on the data ports. This is the
default value.
Refer to Appendix I, “Network Out-of-Band Management” in
the Management and Configuration Guide for more informa-
tion on out-of-band management.
The
listen
parameter is not available on switches that do not
have a separate out-of-band management port.
Syntax:. show console
Shows the current configuration of IPv4 and IPv6 inbound
telnet permissions, as well as other information. For both pro-
tocols, the default setting allows inbound sessions.
HP Switch(config)# show console
Console/Serial Link
Inbound Telnet Enabled [Yes] : Yes
Web Agent Enabled [Yes] : Yes
. . .
Inbound Telnet Setting for
IPv4 and IPv6 Telnet