To Set the Clock
The clock must be set for the
automatic oven timing functions to
work properly. The time of day
cannot be changed during Timed
1. Press the CLOCK
CLOCK
pad.
or CLEAN cycle.
1
2. Press the INCREASE
A
or DECREASE pad
to set the time of day.
Timer
To Set the Timer
The timer is a minute timer only.
The timer does not control oven
operations. The maximum
setting on the timer is
1. Press the TIMER
TIMER
ON/OFF pad.
ON/OFF
55
2. Press the INCREASE or
DECREASE pad to set the
amount of time on timer.
The timer will start automatically
within a
seconds of releasing
the pad.
The timer, as you are setting it,
will display seconds
60
seconds is reached.
Then it will display minutes
and seconds
60 minutes
is reached.
After 60 minutes, it will display
hours
now appears in
display) and minutes until the
maximum time of 9 hours and
55 minutes is reached.
To Reset the Timer
To Cancel the Timer
“TIMER” is displayed, press the INCREASE or
Press and hold the TIMER ON/OFF pad until the
DECREASE pad until the desired time is reached.
word “TIMER” disappears from the display.
If ‘TIMER” is not displayed, press the TIMER
ON/OFF pad first, then follow instructions above
to set the timer.
End of Cycle Tones
Display Messages
The end of cycle tone is 3 short beeps followed by
If “door” appears on the display, the door is open.
I beep that repeats every 6 seconds until you press
Close the door. If “LOCK” appears on the display, the
operation. If you would like to eliminate the
oven door is in the locked position. BAKE, BROIL
repeating beeps, press and hold the CLEAR/OFF
and COOK TIME cannot be set if the door is in the
pad
10 seconds.
locked position.
To return the end of cycle tone to the repeating beeps,
press and hold the
pad for seconds.
Power Outage
After a power outage, when power is restored, the
display will flash and time shown will no longer be
correct-for example, after a 5-minute power
interruption the clock
be 5 minutes slow. The
display flashes until the
is reset. All other
functions that were in operation when the power went
out will have to be programmed again.
9
