26
PROBLEM: The displays of the console do not function properly
a.
Remove the key and unplug the power cord.
Remove the 1/4" x 1" Screws (2) attaching the Motor
Hood (1), and lift off the Motor Hood.
Locate the Reed Switch (34) and the Magnet (16) on
the left side of the Pulley (73). Turn the Pulley until
the Magnet is aligned with the Reed Switch.
Make
sure that the gap between the Magnet and the
Reed Switch is about 1/8 in. (3 mm).
If necessary,
loosen the #8 x 1/2" Screw (123), move the Reed
Switch slightly, and then retighten the Screw.
Reattach the Motor Hood (not shown). Then, run on
the treadmill for a few minutes to check for a correct
speed reading.
PROBLEM: The console displays remain lit when you remove the key from the console
SOLUTION:
a. The console features a display demo mode, designed to be used if the treadmill is displayed in a
store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off
the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE
INFORMATION MODE on page 18 to turn off the demo mode.
2
2
1
16
Top
View
73
123
34
1/8 in.
a
