7
3
4
Avoid pinching
the wires
Wire Tie
Frame
Wires
Frame
Wires
56
56
1
4
20
4
3. Slide the Upright Cover (20) onto the Upright
(4).
Make sure that the Upright Cover is ori-
ented as shown.
Then, slide the Upright Cover
upward toward the top of the Upright.
Have a second person hold the Upright (4) near
the Frame (1). Locate the wire tie (see the inset
drawing) in the Upright. Tie the lower end of the
wire tie to the frame wires. Next, pull the upper
end of the wire tie upward out of the top of the
Upright. Then, untie and discard the wire tie.
Tip: Do not allow the ends of the frame wires
to fall into the Upright. Use a piece of tape or
an elastic band to hold the wires in place
until step 4.
Tip: Avoid pinching the frame wires.
Slide the
Upright (4) onto the Frame (1). Attach the
Upright with four M8 x 20mm Flat Head Screws
(56).
Then, slide the Upright Cover (20) downward to
the bottom of the Upright (4).
4. While a second person holds the console
assembly near the Upright (4), connect the con-
sole pulse wires to the frame pulse wires. Then,
connect the console wires to the frame wires.
Tip: Avoid pinching the wires.
Attach the con-
sole assembly to the Upright (4) with four M8 x
20mm Screws (57).
Console
Assembly
Console
Wires
Frame
Wires
57
Console
Pulse Wires
Frame Pulse
Wires
Avoid pinching
the wires
5.
Make sure that all parts of the exercise cycle are properly tightened.
Note: Some hardware may be left
over after assembly is completed. To protect the floor or carpet from damage, place a mat under the exercise
cycle.
