Fitting the HRT4-ZW Room Thermostat
Before final installation it is advisable to commission the product and ensure that the
Thermostat and Receiver are communicating satisfactorily. First install the 2 type AAA
batteries provided making sure that
they are fitted correctly as indicated
by the markings in the battery
compartment.
Once the thermostat and receiver
are successfully ‘paired’ the
thermostat can be installed in its
correct location. Please see Z-
Wave pairing instructions on page
8.
Avoid installing the thermostat
against or behind any large metal
surfaces which could interfere with the radio signals to and from the CentaurPlus timer
with combined receiver. The HRT4-ZW should be mounted on an internal wall
approximately 1.5 metres from floor level using the wall plate provided and should be in a
position away from draughts, direct heat and sunlight. Ensure that there will be enough
space to allow easy access to the two retaining screws located at the base of the wall
plate.
Before fixing the wall plate in position check to see that the thermostat and boiler are still
able to communicate satisfactorily by turning the thermostat temperature up and down to
switch the boiler on and off.
Offer the plate to the wall in the position where the HRT4-
ZW is to be mounted and mark the fixing positions through
the slots in the wall plate. Drill and plug the wall, then
secure the plate into position. The slots in the wall plate
will compensate for any misalignment of the fixings.
Complete the installation by swinging the room
thermostat into position by engaging with the lugs
at the top of the wall plate before pushing it
carefully home into its plug in terminal block.
Tighten the 2 captive screws on the underside of the
unit.
Now ensure that the heating system is responding to
the ON/OFF commands from the Room Thermostat
and explain its operation to the householder before
handing over the User Instructions.
11
