horsch Terrano 5 FM, Operating Instructions Manual

Page: 37 / 42

33
Maintenance schedule Terrano 5 / 6 / 7 FM
After the first few operating hours Work instructions Interval
Retighten all screw and plug-in
connections, hydraulic connections and
the wheels
Due to material settlements or e.g. paint residues
between screw connections or on wheel studs even
properly tightened screw connections can become loose,
resulting in leaking hydraulic connections and worn out
bore holes in the wheel rims.
Retighten the wheels - all
M18 x 1.5 - 300 Nm
M22 x 1.5 - 510 Nm
¾
initially after 10 hours or 50 km
¾
then after 10 hours or 50 km
¾
then retighten every day, until the screws have settled
and further tightening is no longer possible
¾
then always before the start of the season and every 50
operating hours.
in operation
Lubrication points
Drawbar
Bolts on frame (2) daily
Frame Lid bolts (4) 50 hours
Undercarriage Lift spindle mounting (4) daily
Wheel hub (1 each) 50 hours
Bolts on top of lift cylinder (2) daily
Support wheels / additional support wheels Wheel hub (1 each) 50 hours
Disc levelling Adjusting screw (1 each) 50 hours
Brake Adjusting unit (1 each) 50 hours
Machine
Tines, tine holders and trip-release
system
Check for condition, tight fit and wear daily
Tool carrier Check fastening and retighten with 400 Nm 50 hours
Coulter and coulter fastening Check for condition, tight fit and wear daily
Packer, structural components and
scrapers
Check condition, bearings, fastening and state of wear daily
Spade discs Check condition, bearings, fastening and state of wear daily
Frame and frame connecting parts Check condition and tight fit daily
Hydraulic system and components Leak tightness, fastening and chafing
Wheels undercarriage Check condition, fastening and air pressure (3.5 bar) see above
Front support wheels / additional support
wheels
Check condition, fastening and air pressure (2.6 bar) see above
Brake system (Option). Check function, check lines for leaks, kinks and chafing. prior to use
(Air brakes) Drain air reservoir daily
Parking brake Check function prior to use
Road lighting equipment and safety
covering
Condition, function and cleanliness prior to use
Hydraulic hoses, lifting hydraulics replace (acc. to machine directive) 3-5 years
at the end of the season
Complete machine Carry out servicing and cleaning work
Brake system Release parking brake, drain air reservoir, close brake
lines, check setting.
Levelling discs Spray mounting with penetrating oil
Piston rods on hydraulic cylinders Use penetrating oil or other means to protect piston rods
against corrosion
Maintenance overview Terrano FM