horsch Terrano 5 FM, Operating Instructions Manual

Page: 27 / 42

23
With the cylinders fully extended (area (2) no
clips) the coulters will just touch the ground.
Adjusting the working depth:
¾
Observe the ratio of 1:3.
Example:
For a desired working depth of 12 cm insert
clips with a total thickness of 4 cm in area (2).
During work in the field increase or reduce the
working depth as required.
In the field lower the machine and raise the
chassis. Switch the control unit (Lift/Lower) to
the float position.
Mechanical depth setting
The aluminium clips for depth setting are
plugged on the setting bar.
The clips may only be removed, respectively
inserted when the respective side is relieved.
It is therefore necessary to raise or lower the
machine so that either the packer or the support
wheels are loaded or relieved.
1
2
3
Adjustment rod mechanical depth setting with
adjustment ranges (support wheels)
Adjustment rods with clips (packer)
¾
On all adjusting rods on support wheels and
on packers
use clips in the
same
quantity
and colour.
¾
Always fill all adjustment areas (1) and (2)
completely with clips, if this is possible.
¾
Insert clips, which are not required, in area (3).
Increase the working depth:
¾
Slightly lift the machine.
¾
Remove clips from area (1).
¾
Lower the machine.
¾
Reinsert the clips in area (2).
Reduce the working depth:
¾
Lower the machine.
¾
Remove clips from area (2).
¾
Lift the machine.
¾
Reinsert the clips in area (1).