horsch SW 600, Owner'S Manual

Page: 88 / 100

88 SW600 Owner’s Manual – Version 1.2 07/2018
www.horsch.com
Fasteners should be replaced with the same or higher property class. If higher property class fasteners
are used, these should only be tightened to the strength of the original.
Make sure fastener threads are clean and that you properly start thread engagement. This will prevent
them from failing when tightening.
Tighten plastic insert or crimped steel-type lock nuts to approximately 50 percent of the dry torque shown
in the chart, applied to the nut, not to the bolt head. Tighten toothed and serrated-type lock nuts to the
full torque value.
Metric Conversions Table
Convert from Standard to Metric – multiply by the following factors: