horsch SW 600, Owner'S Manual

Page: 79 / 100

SW600 Owner’s Manual – Version 1.2 07/2018 79
www.horsch.com
of the guide lug is occurring, track alignment may need to be adjusted. For additional
information, refer to the “Track Alignment Procedure” section.
4.
Inspect idler, mid-roller and mid-roller pivot axles for leaks. If any are noted, check oil level
of the hub to be sure oil is up to the fill hole when on a level surface.
Weekly Maintenance, or every 50 working hours
1. Grease upper carrier hubs, undercarriage and track system pivot points.
1 – Tandem Pin, Front 5 – Carrier Roller, LH (if equipped)
2 – Bogie Pin, Front Tandem 6 – Carrier Roller, RH (if equipped)
3 – Main Central Pin 7 – Tandem Pins, Rear
4 – Bogie Pin, Rear Tandem 8 – Tension Link Pin
Monthly Maintenance, or every 100 working hours
1. Check track tension. Refer to chart below for recommended setting. Refer to “Adjusting track
tension” for additional information. No tension adjustment is required if spring module is
functioning properly.
TTS Series
Tensioner Type
Spring Setting
45/70/80/100 Spring No preload-onset of compression less one turn
2. Verify wheel bolt torque (always torque after wheel removal regardless of hrs.).
Wheel bolt size Torque (N-m) Torque (ft-lb)
M16 320 +/- 64 236 +/- 47
M20 620 +/- 124 457 +/- 124