Machines with ball and socket coupling:
- Raise the drawbar with the support far
enough to allow driving with the seed
wagon under the spherical cap.
- Position the ball under the spherical cap.
Lower the drawbar or spherical cap with
the support onto the ball.
- Position the hold-down.
- Check the gap between hold-down and
spherical cap and adjust; see chapter
Maintenance overview
.
5. Connecting the brake.
6. Remove the support and secure it with bolt
and cotter pin in the parking position:
Support in parking position
7. Insert the wheel chocks into the brackets
provided and secure them.
8. Connect the hydraulic lines, see chapter
Hydraulics
.
Watch out for the marks and stick-
ers on the seed wagon.
HZ
SZ
HK
SK
B
A
R1
R2
L1
L2
Z1
Z2
00384071
Connections on the seed wagon
9. Connect the pneumatic hoses and tighten
the clamps.
Pull the hoses (A) over the pipe (B) on the
seed wagon and fasten them with clamps (C).
Fasten the hoses in such a way, that they will
not get damaged during operation and the
pneumatic system stays leak tight.
a
b
c
NOTE
To avoid drilling faults, the seed hoses must
always be plugged on the correct pipe.
¾
Observe the direction of flow of the hoses. It
is marked by an arrow.
10. Connecting lighting and ISOBUS.
32
Summary of Contents for Pronto 8 SW
