Horizont 210221-0903, Operating Instructions Manual

Page: 12 / 19

22 23
+ / rd
Clamp 9 +10
PWM / bn
Status/ wh
GND /bk
Clamp 3 + 4
Versorgung
-
+
Connection diagramms
RS2000 PLUS 4D TO
MS340 PLUS 4D TO
Connection clamp
The stripped, twisted cable is
inserted into the connector so
far that the insulation reaches
the clamp housing!
1
3
2
0,5 - 0,75mm
2
8
use small
screwdriver to press
down carefully
Defective circuit boards, remote controls etc. please send to the following address with a short error
description:
horizont group gmbh
Division gerätewerk
Reparaturabteilung
Homberger Weg 4-6
34497 Korbach, GERMANY
Activation and de-activation of features
By means of adding or removing cable bridges, features can be activated, respectively de-activated.
Operation without additional MS 340 advanced warning lights
When operating without additional MS340 advanced warning lamps, the input „status right“ and „PWM“ must
be connected with each other (wire bridge).
In this way the control unit recognizes, after switching on, whether additional headlights are connected and
should be controlled. In this case the third LED on the main control unit lights up permanently.
Possibly existing cable feed-through for additional MS 340 LED advanced warning lamps must be sealed
against water penetration.
D
EC
KB
L2
D
EC
KB
L1
LI
N
IR
E
SP
IT
ZR
E
LI
N
IL
I
SP
IT
ZL
I
AC
H
TU
N
G
G
N
D
+
+
PWM
PWM
STATUS
STATUS
GND
GND
PWM
status right
Additional advanced
warning lights
MS340 Plus (LED)
Controller
+
status left
Operation with additional MS 340 LED advanced warning lights
Any supplied control unit can be retrofitted with additional MS340 advanced warning lamps at any time.
For part no. 210201-15x, 210502-09x and 210501-15x a supplementary set can be ordered.
The additional advanced warning lights are going to be mounted to the lower part of the light arrow, see
picture page 26 and overview on the electrical lifting and lowering device
Operation with rotating arrow
In case the HLPK 15 is mounted on a warning trailer with rotating arrow device
Wiring of the rotating arrow actuator
+actuator - brown (bn)
-actuator - blue (bu)
Com. GND - white (wh)
sensor retracted - yellow (ye)
sensor centre - green (gn)
sensor extended - red (rd)
Linear actuator LA12 with
integrated limit position switches