EN
Battery Installation and ESC Arming
A
B
C
B
Center of Gravity (CG)
80-85mm
back from leading edge at the root.
Battery Selection
We recommend the Kinexsis
®
14.8V 2400mAh 30C 4S LiPo Battery, 12AWG: EC3
™
(KXSB0016) for standard operation. If using a different battery, the battery should
be of similar capacity, dimensions and weight of the Kinexsis Li-Po battery pack
to fi t in the fuselage. Always be sure the model balances at the recommended CG
with the battery chosen.
1. Lower the throttle and throttle trim to the lowest settings. Power on the
Transmitter, then wait 5 seconds.
2. Apply the loop side (soft side) of the hook and loop tape (
A
) to the bottom of
your battery.
3. Carefully lift the back of the canopy hatch (
B
) to remove.
4. Install the fully charged battery in the battery compartment as shown.
See the
Adjusting the Center of Gravity instructions for more information.
5. Make sure the fl ight battery is secured.
6. Connect the battery to the ESC (
C
) (the ESC is now armed).
7. Keep the aircraft immobile and away from wind or the system will not initialize.
The ESC will sound a series of tones. If the ESC sounds a continuous double beep
after the fl ight battery is connected, recharge or replace the battery.
8. Reinstall the canopy hatch.
The CG location is measured from the leading edge of the wing at the root.
This CG location has been determined with the recommended Li-Po battery
installed all the way forward in the battery compartment.
7
