Horizon Fitness Perfect Binder BQ-260, Manual

Page: 87 / 94

81
10. Installation of Friction Cover Feeder CF-220
20 mm
10-2 Set Up
NOTE
See "10-2-2 Position Set Up for Cover longer
than 550 mm" in page 84 when cover is
longer than 550 mm.
1.
Loosen two lock knobs on cover feeder
base and slide cover feeder unit fully to
operation side by cover feeder handle.
2.
Open safety cover
3.
Select support plate according to cover
size.
4.
Place support plate on front nipper jaw.
- Support plate must project over 20 mm
from front nipper jaw.
NOTE
Support plate is used as a bridge between
cover feeder unit and nipper unit.
Lock Knobs
Cover Feeder
Handle
Cover Stock
Support Plate
Front Nipper Jaw
Support Plate
WARNING
Do not set up cover feeder position too
close to nipper unit, cover feeder will
touch nipper unit.
20 mm
Support Plates
NOTE
When your binding job is pad binding (with-
out cover), cover feed unit set up is not neces-
sary to perform. Proceed to "4-4 Vertical
Stacker Unit Set Up" in page 29.
This section shows how to adjust cover feeder
position.
10-2-1 Position Set Up