F
UNCTION
B
OARDS
80 / 98
6842 GPS Slim Line System - V09.01
hopf
Elektronik GmbH
Nottebohmstr. 41 • D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: [email protected]
A slot with a Bus Bridge Board must be available.
•
Switch the equipment off.
•
Unscrew the Bus Bridge Board and pull it out of the System.
•
Set all DIP and jumper settings for the desired functions on the Function Board.
•
Insert the new Function Board into the System and tighten the screws.
•
Make all connections to the Function Board.
•
Switch the equipment back on.
•
Configure the Function Board via the System 6842 menu as necessary.
6.5 Removing Function Boards
The following steps are required in order to remove a Function Board from the System:
•
Switch the equipment off.
•
Isolate all connections to the Function Board to be removed.
•
Unscrew the Function Board and pull it out of the System.
•
Insert the Bus Bridge Board into the System and tighten the screws.
•
Switch the equipment back on.
A removed Function Board
must
be replaced by a Bus Bridge Board in order to
guarantee the operation of the System.
