COM0 / COM1 S
ERIAL
I
NTERFACES
50 / 98
6842 GPS Slim Line System - V09.01
hopf
Elektronik GmbH
Nottebohmstr. 41 • D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: [email protected]
5.1.2.2 Mode Byte 1 / Bit 6 - Serial Output Second Forerun
Bit Position 6 Second Forerun
Off
With second forerun
On
Without second forerun
See also
Chapter 5.2 Data String Transmission Points of Time
.
5.1.2.3 Mode Byte 1 / Bit 5 - Bit 5 currently no function
Bit Position 5
Off Free
On Free
5.1.2.4 Mode Byte 1 / Bit 4 - Last Control Character at Second Change
(On-Time Mark)
The last control character (see data string construction) can be transmitted exactly at the
next second change with this setting.
Bit Position 4
Control Character at Second Change
Off
With control character at second change
On
Without control character at second change
See also
Chapter 5.2 Data String Transmission Points of Time
.
This function is usually used in conjunction with the "with second forerun"
setting.
5.1.2.5 Mode Byte 1 / Bit 3 - Reverse Control Characters CR and LF
The character sequence CR and LF can be reversed with this switch.
Bit Position 3 Control Characters CR and LF
Off
LF/CR sequence as in string description
On
LF/CR sequence reversed from string
description
5.1.2.6 Mode Byte 1 / Bit 2 - Delayed Transmission
The last character of the data string is transmitted directly at the second change and
immediately thereafter the new data string, which is valid for the next second change, is
transmitted with the setting "Control Character at Second Change". This can be interpreted
as an error on some computers with a high working load. With Bit Position 2, transmission of
the new data string can be delayed dependent on the baud rate.
Bit Position 2 Transmission Delay
Off
With delayed transmission
On
Without delayed transmission
See also
Chapter 5.2 Data String Transmission Points of Time
.
