F
UNCTION
B
OARDS
6842 GPS Slim Line System - V09.01
79 / 98
hopf
Elektronik GmbH
Nottebohmstr. 41 • D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: [email protected]
6.3 Exchanging a Function Board
To exchange a Function Board for an identical board model whilst retaining all previous
functions requires the following steps:
•
Switch the equipment off
•
Remove all connections to the Function Board to be exchanged
•
Unscrew the Function Board and pull it out of the System
•
Transfer all DIP and jumper settings from the old Function Board to the new board
•
Insert the new Function Board into the System and tighten the screws
•
Remake all connections
•
Switch the equipment back on
•
Set Function Board to the desired configuration via the System 6842 GPS menu if
necessary
Software settings must
always
be set after replacing a function board by
using the menu in order that the new function board takes over the
parameters. Otherwise the parameters of the old board will be displayed but
the new board doesn't take over the new one.
6.4 Installation of an Additional Function Board
In principle every Function Board can be installed at any desired point on the System 6842
GPS.
Exceptions:
o
Slave Line Board 7406 with any internal line voltage wiring
If the System is not prepared for the Board 7406 in the factory then the
required line voltage must be made available for the Board 7406 externally.
o
Function Boards with any system-internal wiring
The details of slots which are wired at the time of delivery can be found in the
System drawing / specifications.
