S
YSTEM
P
ARAMETERIZATION AND
O
PERATION
6842 GPS Slim Line System - V09.01
29 / 98
hopf
Elektronik GmbH
Nottebohmstr. 41 • D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: [email protected]
4.1.1.5 Serial Interface Parameters
The serial interface parameters and the output mode can be input separately for each of the
two serial interfaces. The following selection frames appear (for parameterization see
Chapter 5 COM0 / COM1 Serial Interfaces
).
4.1.1.5.1 Selection Frames for COM0 Serial Interface Parameters
Setting the Serial Parameters
Selection frame:
S E T C O M _ 0 S E R I A L
P A R A M E T E R Y / N _
The parameters for
B
aud rate,
W
ord length,
P
arity bit,
S
top bit and
H
and
S
hake must be
entered in sequence in the following input frame:
Input frame:
B :
0 9 6 0 0
W :
8
P :
N
S :
1
H S :
N
_
Setting Mode Byte 1
Selection frame:
S E T C O M _ 0
M O D E _ 1 Y / N _
Input frame:
B I T 7 6 5 4 3 2 1 0
1 1 1 0
1 1 0 0
_
Setting Mode Byte 2
Selection frame:
S E T C O M _ 0
M O D E _ 2 Y / N _
Input frame:
B I T 7 6 5 4 3 2 1 0
1 1 1 0
1 1 0 0
_
4.1.1.5.2 Selection Frames for COM1 Serial Interface Parameters
S E T C O M _ 1 S E R I A L
P A R A M E T E R Y / N _
The parameters for the COM1 interface are entered in the same way as for COM0.
4.1.1.5.3 Selection Frames for Optical Interface Parameters
S E T O P T I C A L T R N S
P A R A M E T E R Y / N _
The optical interface is not supported in this equipment version. However,
the selection frames are present in the same way as COM0.
