OPERATION
6
Fill the clean water tank
with warm water
(max 40°C).
Select the SpinScrub or Upholstery tool. Slide the
tool over the tab at the end of the hose until it clicks
into place.
Pull down the accessory
hose connector cover.
Turn the wash/rinse
dial to ‘wash’.
Plug into the mains and
press the On/Off button
to switch on.
NOTE:
The carpet washer should be in the upright position when using the hose and tools; this will
de-activate the SpinScrub brushes and brushbar.
NOTE:
Use the carpet washer or hose to pick up spills before washing and cleaning the area.
Pour the required
amount of carpet
cleaning solution into
the tank.
Press the trigger on
the hose to release
solution/water.
Squeeze the trigger on the forward stroke and
release the trigger on the backward stroke to pick
up water/solution. For a dryer finish, follow with
an additional dry stroke with no trigger pressed.
Push the hose end and
hose solution connector
into the hose and
solution connection port.
Using the hose and tools
RINSE
WASH
