10
MAINTENANCE
Remove both tanks and
tilt the carpet washer
back.
Lift the nozzle release
clip and pull the nozzle
forward, separating the
tabs on the nozzle and
carpet washer.
To replace the nozzle,
line up the tabs on the
nozzle with the tabs
underneath the front of
the carpet washer.
Push the nozzle down
until it clicks into place.
Rinse the nozzle under
water to remove
dirt/debris.
CAUTION:
Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
Removing and cleaning the nozzle
Lie the carpet washer
on its back exposing
the SpinScrub brushes
and brushbar.
Firmly pull the sides
of the SpinScrub
cover and remove the
SpinScrub brushes.
Line up the spindle and
tabs on the side of the
SpinScrub cover into
carpet washer, push
firmly until it clicks into
place.
Using a pair of scissors,
remove any threads or
hair caught around the
brushes. Rinse under
water to remove debris.
IMPORTANT:
If the nozzle is fitted incorrectly, this will cause poor dirty water pick up.
Removing and cleaning the SpinScrub brushes
NOTE:
Carpets and hard floors should be dry vacuumed thoroughly before washing.
This will help prevent excessive build up of dirt/debris in the nozzle.
