OPERATION
3
Stand the base of the
carpet washer on the
floor in the upright
position. Line up the
handle with the main
body and push into
place.
Turn handle lock dial
clockwise to lock in
position.
Assemble the tanks by
tilting and lining up the
front of the tank to the
washer and pushing
the tank back until
it clicks into place.
Slide the SpinScrub
tool holder over and
down the handle.
PLEASE READ ‘GENERAL SAFETY INFORMATION’ AT THE BEGINNING BEFORE USE
Assembling your carpet washer
IMPORTANT:
Carpets should be dry vacuumed thoroughly before washing.
Test for colourfastness – Wet a white absorbent cloth with the solution. In a small hidden area of your
carpet/rugs/upholstery gently rub with the dampened cloth. Wait ten minutes and check for colour
removal or bleed with a white paper towel or cloth. Check all carpets/rugs/upholstery material before
first use and If your carpet has more than one colour, check all colours.
Test all carpets/rugs/upholstery before full usage. Run the carpet washer over a small hidden area.
If no damage or pile distortion occurs continue cleaning.
When cleaning an entire room, move furniture out of the area to be cleaned. If the furniture cannot be
moved, place aluminium foil or wax paper under the legs. This will prevent wood finishes from staining
your carpet. Pin up furniture skirts and curtains.
When using the carpet washer, basic safety precautions should always be observed and don’t over
saturate your carpets.
Only use Vax carpet solution. Using other solutions may cause excess foaming and will invalidate your
guarantee.
The clean water tank should only be filled with warm water (max 40°C). Filling the clean water tank with
hot/boiling water will damage your machine and invalidate the guarantee. This is a powerful carpet
washer, before plugging in make sure all controls are turned off and hold the carpet washer firmly when
starting and during use.
Line up the SpinScrub tool
with the holder and slide the
tool downwards into place.
