OPERATION
4
Press the clean water/
solution tank release
button, pull and lift to
remove the tank.
Tilt and line up the
front of the tank to the
washer and push the
tank back until it clicks
into place.
Turn the wash/rinse
dial to ‘wash’. The
SpinScrub brushes and
brushbar deep clean
your carpets with water
and solution removing
dirt and stains.
Fill the clean water tank
with warm water (max
40°C). Fill to max fill
line for a Deep Clean,
and fill to the Quick
Clean fill line for a
quick surface clean.
Pour the required
amount of carpet
cleaning solution into
the tank. Tighten the
cap before returning
the tank to the washer.
Plug into the mains, press
the On/Off button to
switch on.
Choose the cleaning
mode by turning the dial
on the base.
Quick Clean Mode:
Best for a quick, surface
clean - carpets dry in
less than an hour.*
Deep Clean Mode:
Best overall results for
a thorough, deep clean.
Twist the water/solution
tank cap anti-clockwise
and remove.
Filling the water/solution tank and cleaning modes
NOTE:
Carpets should be dry vacuumed thoroughly before washing. For heavily soiled areas, it may
be necessary to repeat the cleaning process. Make criss-crossing strokes across the original pattern and
overlap with each pass.
NOTE:
This machine has an auto mix tank so any
solution not used can be poured back into the bottle.
*Tested on PP and Wool - Nylon carpet. Results may vary.
RINSE
WASH
