9
Clean the filter screen
located at the back of
the dirty water tank.
Empty the dirty water
over the sink. Rinse the
dirty water tank and lid
under water (max 40°C)
to remove dirt/debris.
To re-fit, tilt the dirty water
tank and line the front of
the tank up onto the carpet
washer. Push back until it
clicks into place.
Pull and lift the dirty
water tank clip to
release the lid. Lift the
tank lid to remove.
Press the dirty water
tank release latch and
pull the tank to remove.
MAINTENANCE
CAUTION:
Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
Emptying and cleaning the dirty water tank
IMPORTANT:
Empty and rinse out the clean and dirty water tanks and leave to air dry before replacing.
Do not leave solution stored in the tanks between uses.
