OPERATION
5
Refreshing carpets
IMPORTANT:
When using on carpets, always make sure the microfibre cleaning pad is used
and covers the floorhead entirely before using the carpet glider. Only use the carpet glider when
refreshing carpets.
Place the microfibre pad on
the floor white side facing up.
Place steamer onto pad
making sure the entire pad
covers the floorhead.
Twist the steam control dial
to desired setting. Steam is
activated automatically.
Take care when changing
settings during cleaning.
Twist the steam control dial to desired setting. Steam is activated
automatically. Take care when changing settings during cleaning.
With microfibre pad attached,
push steamer into front of
the carpet glider, then place
back of the floorhead into
the clip. The carpet glider
should only be used when
refreshing carpets.
Place your foot on floorhead
and pull handle backwards
to recline.
Plug into mains, turn dial to
‘ON’ position, the red light
will illuminate to indicate
power on. There will be no
sounds for the first 30 seconds
whilst it is heating up.
Move the steamer slowly
backwards and forwards
across the carpet paying
particular attention to high
traffic areas.
NOTE:
Switch OFF and allow to cool first.
Steam is automatic in stick mop mode.
