OPERATION
4
Cleaning hard floors
IMPORTANT:
Never use the steamer without a microfibre cleaning pad attached to the floorhead.
Never leave the steamer on one spot for an extended period of time or with a damp or wet
microfibre pad attached as this may damage the floor surface.
Place the microfibre pad on
the floor white side facing
up. Place the floorhead onto
microfibre pad making sure
the microfibre pad covers the
entire floorhead.
Place foot onto the floorhead
and pull handle backwards to
recline.
Plug into mains, turn dial
to ‘ON’; the red light will
illuminate to indicate power
on. The steamer will be
ready after approximately
30 seconds. There will be no
sounds for the first 30 seconds
whilst it is heating up.
Move the steamer slowly
backwards and forwards
across the floor paying
particular attention to high
traffic areas.
To steam your floors twist the
steam control dial to desired
setting. Steam is activated
automatically. Take care when
changing settings during
cleaning.
Turn dial to ‘OFF’ position
and allow steamer to cool,
the amber light will switch
off. Hold corner of pad
down with your foot and
lift steamer to peel away.
