Honeywell VOYAGER 1200G, User Manual

Page: 87 / 288

3 - 23
Auto Reconnect Mode
Auto Reconnect controls whether or not the scanner automatically begins
the relink process when a loss of connection is detected. When the
Auto
Reconnect On bar code is scanned, the scanner begins the relink process
immediately, without user intervention. Default = Auto Reconnect On.
The following table shows the results of the Auto Reconnect On and Off
settings:
Event Auto Reconnect On Auto Reconnect Off
Scanner out of
range Relink occurs
automatically. If
maximum number of link
attempts is
unsuccessful, then the
scanner must be
relinked by either
pressing the scanner’s
button or placing the
scanner in the base.
(See
Maximum Link
Attempts on page 3-24.)
The scanner is
relinked by pressing
the button.
Base reset
(firmware upgrade
or power cycle) Scanner behaves as if
out of range. No attempt to relink
made while base is
powered off. Button
must be pressed to
initiate relinking.
Scanner reset due
to firmware
upgrade Relink occurs automatically.
Scanner reset due
to battery change Relink occurs automatically.
Scanner placed in
different base unit Relink to new base occurs automatically.
* Auto Reconnect On
Auto Reconnect Off