Honeywell UDC3200 series, Product Manual

Page: 76 / 243

Configuration
3.9 Input 1 Set Up Group
Introduction
This data deals with various parameters required to configure Input 1.
Function Prompts
Table 3-9 INPUT 1 Group Function Prompts
Function Prompt
Lower Display
Selections or
Range of Setting
Upper Display
Parameter
Definition
IN1 TYPE
ATTENTION
Changing the input
type will result in the
loss of Field
Calibration values and
will restore Factory
Calibration values.
DISABLE
B TC
E TC H
E TC L
J TC H
J TC M
J TC L
K TC H
K TC M
K TC L
NNM H
NNM L
NIC H
NIC L
R TC
S TC
T TC H
T TC L
W TC H
W TC L
100 PT
100 LO
200 PT
500 PT
RAD RH
RAD RI
0-20mA
4-20mA
0-10mV
0-50mV
0-100mV
0-5 V
1-5 V
0-10 V
TC DIFF
CARBON
OXYGEN
INPUT 1 ACTUATION TYPE – This selection
determines what actuation you are going to use for
Input 1.
DISABLE —Disables Input.
B TC —B Thermocouple
E TC H —E Thermocouple High
E TC L —E Thermocouple Low
J TC H —J Thermocouple High
J TC M —J Thermocouple Med
J TC L —J Thermocouple Low
K TC H —K Thermocouple High
K TC M —K Thermocouple Med
K TC L —K Thermocouple Low
NNM H —Ni-Ni-Moly Thermocouple High
NNM L —Ni-Ni-Moly Thermocouple Low
NIC H —Nicrosil-Nisil Thermocouple High
NIC L —Nicrosil-Nisil Thermocouple Low
R TC —R Thermocouple
S TC —S Thermocouple
T TC H —T Thermocouple High
T TC L —T Thermocouple Low
W TC H —W5W26 Thermocouple High
W TC L —W5W26 Thermocouple Low
100 PT —100 Ohm RTD High
100 LO —100 Ohm RTD Low
200 PT —200 Ohm RTD
500 PT —500 Ohm RTD
RAD RH —Radiamatic RH
RAD RI —Radiamatic RI
0-20mA —0 to 20 Milliamperes
4-20mA —4 to 20 Milliamperes
0-10mV —0 to 10 Millivolts
0-50mV —0 to 50 Millivolts
0-100mV —0 to 100 Millivolts
0-5 V —0 to 5 Volts
1-5 V —1 to 5 Volts
0-10 V —0 to 10 Volts
TC DIFF —Thermocouple Differential
Carbon —Carbon Probe Input
Oxygen —Oxygen Probe Input
64 UDC3200 Universal Digital Controller Product Manual 12/04