Honeywell TUXWIFIS, Installation And Setup Manual, Page: 47 / 64

47
Keypad Diagnostics and Calibration Tests
Keypad Tests
Keypad Test lets you verify correct operation of the Tuxedo and its connections to the security system.
There are a total of five diagnostic tests;
•
LCD Display Test
•
Audio Test
•
LED Test
•
Calibration
•
Z-Wave Test
Performing Diagnostic Tests
Select any diagnostic test from the “Diagnostics” screen by pressing its associated Test icon. All or any
individual test may be run when you access the “Diagnostics” screen; however, each test must be
performed one at a time. At any time when a test is not being performed, you can press back to return to
the previous screen, or home to return to your home page.
Once the Diagnostics screen is exited, subsequent entry to this screen displays all test options as "Not
Performed."
LCD Display Test
From the "Home" screen, press the Setup > System setup > Advanced Setup icons.
If applicable, enter your authorized code and press the Keypad Test icon.
Press the icon for LCD Display Test ; a series of screens appear.
After each type of display, you are asked if the display was proper. If the response to all questions is yes,
the LCD Display Test message area of the Diagnostics screen displays “
Passed. ”
Audio Test
Press the icon for Audio Test ; " Testing .." is displayed while beeps sound from the speaker. At the
conclusion of the test, a pop-up "Confirmation Window" is displayed with the question "Did you hear
Beeping?"
When you press Yes , "Passed" is displayed in the test status column on the "Diagnostics" screen.
When you press No, "Failed" is displayed in the test status column on the "Diagnostics" screen.
LED Test
Press the icon for LED Test ; "Testing.." is displayed while the 3 LEDs light sequentially, top to
bottom (red, green, yellow), 5 times.
At the conclusion of the test, a pop-up
"Confirmation Window" is displayed with the question "Did you see
chasing LED pattern?"
If you press Yes
,
"Passed" is displayed in the test status column on the "Diagnostics" screen.
If you press No, "Failed" is displayed in the test status column on the "Diagnostics" screen.
The Emergency screen cannot be accessed while running the LCD Display Test.