OPERATOR MANUAL // SECTION 2: INSTALLATION
HONEYWELL
10
2.2
Enclosure Installation
1. INSTALL THE M ODEL SS4-AI DETECTOR SWIVEL M OUNTS
(see Figure 2). Although not required, Honeywell Analytics
recommends using the SM4 Swivel Mounts when installing the
Model SS4-AI Detector.
a. Choose fasteners for the swivel-mount that will secure it
solidly to the type of material at the enclosure location.
b. Mount the swivel-mount to the wall. Do not install upside
down.
c. Install the mounting bracket onto the Model SS4-AI Detector
enclosure using ¼-20 screws and nuts provided. Be sure
the bracket is mounted with the correct orientation. The
outside contours of the mounting ears on the Detector
enclosure and the ends of the bracket will match. The large
diameter of the threaded insert must be facing the
enclosure.
d. Screw the enclosure/bracket assembly on to the ball stud.
Turn the Detector until the stud bottoms against the
enclosure.
Do not tighten.
While holding the enclosure,
tighten the jam nut against the bracket.
e. While holding the enclosure, loosen the socket head screw
on the swivel-mount. Position the enclosure so that the
conduit openings are on the bottom and horizontal. Point
the enclosure in the desired direction and tighten the socket
head screw.
INSTALL CONDUIT (
If not already installed).
Figure 3: Model SS4-AI Detector Enclosure - Side View
