Honeywell Rapid Eye, Installation Manual

Page: 35 / 82

Rapid Eye™ Multi-Media DVR Installation Guide
Document 800-02607V3 Rev A 35
11/09
Common Network
Figure 2-9 LocalView Panel for Network Settings
1. Using LocalView, enter the IP Address of the DVR (see Figure 2-9 ). Click to open
the virtual keyboard (see Figure 2-8 ). Click the keyboard buttons to enter the IP
Address and click OK.
2. Click Enter.
Dynamic Host Configuration Protocol Using DNS
Figure 2-10 LocalView Network Settings with DHCP
1. In Network Settings, enable DHCP on the Rapid Eye DVR (see Figure 2-10 ).
By default, the Site Name in LocalView shows
REM[hyphen][DVR serial
number]
and includes the leading zeroes. The DVR serial number is also printed on a
sticker affixed to the DVR.
If you change the Site Name, make a note of the new name, for setting up a remote
connection using the Admin software.
2. Click Refresh.
164.178.32.1
If you are not using Dynamic
Host Configuration Protocol
(DHCP), enter the IP Address
for your unit manually.
If you are using Dynamic Host
Configuration Protocol (DHCP) to
assign an IP Address for your unit,
select the Use DHCP check box.