Honeywell PX4i, User Manual, Page: 69 / 158

PX4i and PX6i High Performance Printer User Guide 57
2. Send one of the following WPA/WPA2 ON commands to set up WPA-802.1x or
WPA2-802.1x authentication. You should also send the WPA_PSK command
that does not contain a value:
setup "wlan","WPA","OFF"
setup "wlan","WPA2","ON"
setup "wlan","WPA_PSK",""
setup write "wlan","uart1:"
3. To view the 802.1x values, send this command:
setup write "8021x","uart1:"
4. Send these commands to configure the EAP_TYPE:
setup "8021x","EAP_TYPE"," xxxx "
where xxxx can be OFF, LEAP, PEAP, TTLS, or EAP-FAST.
setup "8021x",".EAP_USER"," xxxx "
setup "8021x","EAP_PASS"," xxxx "
where xxxx is the unique username and the unique password for
this protocol.
5. If you are using TTLS, you may need to send this command to set the TTLS
outer name:
setup "8021x","TTLS_USER"," xxxx "
where xxxx is the outer name.
6. If you are using EAP-FAST, you can use PAC and ACQUIRE_PAC commands.
The PAC setting specifies the PAC file to use for EAP-FAST authentication. The
ACQUIRE_PAC setting checks to see if automatic PAC file provisioning is
enabled. You can set ACQUIRE_PAC to on or off.
• Send the following command to set PAC to use /tmp/my.pac with a pass phrase
of “verysecret”:
setup "8021x","PAC","/tmp/my.pac@verysecret"
• Send the following command to set ACQUIRE_PAC to on:
setup "8021x","ACQUIRE_PAC","ON"
7. If you are using certificates for validation, here are some commands you may
need to use.
• Send the following commands to set a certificate and enable validation:
setup "8021x","CA_CERT"," c:/test.pfx @ export "
setup "8021x","VALIDATE","ON"
where c:/test.pfx is the location and name of the certificate
on the printer and export is the passphrase.
• Send the following commands to set a common name for server 1 and server 2:
setup "8021x",".SERVER_CN1"," xxxxxxxxxx"
setup "8021x",".SERVER_CN2"," xxxxxxxxxx"
where xxxxxxxxxx is at least 8 characters but less than 96
characters.
• Send the following commands to make sure your values match those used by
the access point:
setup write "8021x","uart1:"
setup write "wlan","uart1:"