4/6
S-8109.1-TAD-FTT-ENG Rev. A.2 01/2018
Terminal with back light and display.
TAD-FTT
Check on the line UP/DOWN enable, there is
written YES, modify if it necessary
move
' on correct ACSE- page
press
put in the value (in second)
press
to confirm the configuration
Press
to return at the normal operation
TEMPERATURE SENSOR
The temperature sensor is already calibrated on the
factory configuration, to make a new calibration or to
adapt on the installation:
Remove peripheral power
Power the peripheral
While viewing the Firmware versione, press
and hold untill you see installer menù
Press L6, SENS. TEMP
With
' adjust the teperature
press
to confirm the configuration
Press
to return at the normal operation
TECHNICAL DATA
Power Supply
9 - 30
Vcc
Standby current
70
mA
Maximun current
170
mA
Operating
Temperature
-10 / +55
°C
Open Collector
Output
400
mA
Temperature sensor
- 55 +
125
°C
Dimensions
L = 135
H = 130
P = 35
mm