3/6
S-8109.1-TAD-FTT-ENG Rev. A.2 01/2018
Terminal with back light and display.
TAD-FTT
No Power Supply, Battery, Fault.
Reports of NO POWER (led LA/L5 page 0), BATTERY
FAULT (LED LD/L6 page 0) and FAULT (LED LB/L7
page one) are managed by the CPU and can be
programmed..
Key Press
1 Beep + turned on LED keypad in YELLOW
Page Viewed
The page that appears is indicated by the
corresponding yellow LED on the keypad
SPECIAL FUNCTION BUTTON
Enter, confirm the selection
Exit, back to the previous menu, when there is not a
qualified operator, display show the device number and
firmware version.
up/down, moving up / down one the selection.
L1 / L5
page up , move the selection up one page
(only in the list).
L4 / L8
page down, move the selection down one
page (only in the list).
L2 / L3
SX, Move the visualizzation on the left (only in
the list)
L6 / L7
DX, Move the visualizzation on the right (only
in the list)
LOCAL PERIPHERAL SET-UP
Factory terminals have enabled all the local devices,
the configuration is designed to eliminate those that are
not installed to improve the response time of the related
MGP_E
Remove peripheral power
Power the peripheral
While viewing the Firmware versione, press
and hold untill you see installer menù
Press L2 Local device, the terminal check and
automatically acquires the devices connected to the
local line, for external antennas as AT-E; AEI-3,
wich is necessary to read a transponder to
determinate
the
acquisition.
The
devices
recognized are highlighted by a S
Press
to confirm the configuration
Press
to return at the normal operation
RECEPTION / TRANSMISSION FIRMWARE
Remove peripheral power
Power the peripheral
While viewing the Firmware versione, press
and
hold untill you see installer menù
Press L3, RECEPTION FIRMWARE if you want to
receive the firmware from another peripheral.
Press L4 TRASMISSION FIRMWARE If you want
send our firmware to another peripheral
The performance of the reception/trasmissioni is
indicated by a meter, the procedure ends when the
counter reaches 512, and the display show the message
FW Scripture, after that the terminal is restarted
N.B. Do not carry out operations or remove power to the
terminal while the SCRIPTURE FW is displayed.
ENABLE PAGE DISPLAY WITHOUT
APPROVAL
Factory visualization of 4 pages of function keys and
LEDs is allowed only after the operator is enabled.
To change these parameters:
Remove peripheral power
Power the peripheral
While viewing the Firmware versione, press
and
hold untill you see installer menù
Press L5, SEQ. VIS. ACS-E.
Move up/down till correct line
press
put the value
press
to confirm the configuration
press
to return at the normal operation.
AUTOMATIC PAGES DISPLAY WITHOUT
APPROVAL
When the visualizzation is permitted without autorizzation
is possible to enable automatically display. For each
pages you con set the display time, when time is zero the
page is not display, if there more pages configurated are
displayed in sequence.
Remove peripheral power
Power the peripheral
While viewing the Firmware versione, press
and
hold untill you see installer menù
Press L5, SEQ. VIS. ACS-E.
