Honeywell HEIPTZ-2201W-IR, User Manual

Page: 35 / 62

Operation
28
Figure 4-19

IPV4: IP protocol version No. is 4

IPV6: IP protocol version No. is 6

Static IP: The device IP address is permanent
 DHCP: Click DHCP, when turn on the router’s DHCP, the camera will get the IP address from router
automatically

IP address: Input the corresponding numbers to change the IP address

Subnet Mask: Input the corresponding IP subnet mask

Gateway: Input the corresponding gateway address

DNS1: DNS server address

DNS2: DNS server standby address

SNMP: To detect whether it will cause any management attention as device connected on the network

SNMP Manager IP : Input the corresponding SNMP manager IP address

HTTP Port: Input the corresponding port ( Default is 80)

HTTPS Port: Input the corresponding port ( Default is 4433)

Enable UPnp: When click Enable UPnp, the device and HTTP port will mapping to the router automatically

Device Port: Input the corresponding device port (Default is 5050)

Enable PPPOE: Click to enable PPPOE server
Username: Input the username
Password: Input the password
Confirm pwd: Input the password again to confirm it
PPPoe IP:Display the IP address
After all parameters setting completed
, click “Save” and the it comes into effect immediately.
Platform Management
Network High Speed Dome
“Platform Management” interface as figure 4-20.