Honeywell Granit XP 199 i Series, User Manual

Page: 73 / 312

Granit XP User Guide 55
Override Locked Scanner
If you need to replace a broken or lost scanner that is linked to a base or an Access
Point, scan the
Override Locked Scanner barcode below with a new scanner and
place that scanner in the base, or scan the Access Point linking barcode. The
locked link will be overridden; the broken or lost scanner’s link with the base or
Access Point will be removed, and the new scanner will be linked.
Out-of-Range Alarm
If your scanner is out range of the base, an alarm sounds from both your base and
scanner. If your scanner is out range of an Access Point, an alarm sounds from just
the scanner. The alarm stops when the scanner is moved closer to the base or
Access Point, when the base or Access Point connects to another scanner, or when
the alarm duration expires. To activate the alarm options for the scanner or the
base and to set the alarm duration, scan the appropriate barcode below and then
set the time-out duration (from 0-3000 seconds) by scanning digits on the
Programming Chart, beginning on page 291, then Save . Default = 0 sec (no alarm).
Note: If you are out of range when you scan a barcode, you will receive an error tone even if
you do not have the alarm set. You receive the error tone because the data could not
be sent to the base or Access Point or the host.
Alarm Sound Type
You may change the alarm type for the scanner or base by scanning the appropri-
ate barcode below and then scanning a digit (0-7) barcode from the
Programming
Chart, beginning on page 291, then Save . Default = 0.
Override Locked Scanner
(Single Scanner)
Note: The Access Point does not have a base alarm.
Base Alarm Duration
Scanner Alarm Duration