Honeywell Granit XP 199 i Series, User Manual

Page: 129 / 312

Granit XP User Guide 111
Satisfactory Subset of Full Sequence Timeout Example
To specify a subset, list its members using the SEQSAT command and terminate
each subset with FF. The members of each subset are specified as single hex digits
corresponding to their index within the full sequence, 1 being the first. For exam-
ple, to specify two subsets, the first consisting of the first and second code in the
sequence and the second subset consisting of the second and third code, use the
command
SEQSAT12FF23FF .
To define a subset with an odd number of codes, insert a 0 before the final code
index. For example, to define a 3-code subset consisting of the first, second, and
third codes, use the command
SEQSAT1203FF .
Default Output Sequence
Default Sequence programs the scanner to all universal values. Be certain you
want to delete or clear all formats before you read the Default Sequence symbol.
Require Output Sequence
When an output sequence is Required, all output data must conform to an edited
sequence or the scanner will not transmit the output data to the host device. When
it’s
On/Not Required , the scanner will attempt to get the output data to conform to
an edited sequence but, if it cannot, the scanner transmits all output data to the
host device as is, or formatted according to the partial sequence output format
(see
Partial Sequence on page 108).
When the output sequence is Off , the barcode data is output to the host as the
scanner decodes it. Default = Off.
Note: This selection is unavailable when the Multiple Symbols Selection is turned on.
Default Sequence
Required
On/Not Required
*Off