Node 1 Domain 1
Port 0: 1200 Off
Port 1: 38400 None
Port 2: 38400 None
Port 3: 38400 None
Connecting the Commissioning Tool to the Panel
Before we can use the Commissioning Tool to communicate
with the Fire Panel we need some details about the panel.
INFO > STATUS > CARD {0} > ENTER
Card 0:
Fault 0 Disable 0 Warning 0
Controller (2) Version 4.37 21/11/06
Node Address
On power up, a new EN Panel
(Without a Network card
Fitted) the node address will
not be set up.
To Change or Setup the Node
Address:
TestEng > Usercode >Config
> Comms > Address
{type in required node
address in the range of 1 to
32} > Enter
Domain Number
On an EN Panel by default
this will be set at
Domain 1.
To Change the Domain
Number if required:
TestEng > Usercode >
Config > Comms > Domain
{type in required Domain
address in the range of 1 to
255} > Enter
Version
3.xx = BS
4.xx = EN
RS232 Ports
Compact Only
Communication Port and Baud Rate:-
Ports 1 & 2 (Compact Panel only) are the serial (RS232) Ports and
Port 3 is the USB port. To change the baud rate use:-
TestEng > Usercode > Config > Comms > Card {0} Enter > {Type the Port No} > Enter > Baud > Enter
> {Use the Previous and Next options to adjust the Baud rate} > Enter
Summary of Contents for Gent Compact Plus
