79
GasAlertMicro 5/PID/IR
Troubleshooting
Troubleshooting
If a problem occurs, refer to the solutions provided in
Table 21.
. If the problem persists, contact
BW Technologies by Honeywell
.
Table 21. Troubleshooting
Problem
Possible Cause
Solution
Startup Troubleshooting
The detector does not
activate.
No batteries
Refer to
Replacing the Alkaline Batteries
or
Replacing the Lithium Battery
Pack
.
Depleted batteries
Refer to
Replacing the Alkaline Batteries
, or
Replacing the Lithium Battery
Pack
.
Damaged or defective detector
Contact
BW Technologies by Honeywell
.
The detector immediately
enters alarm mode when
activated.
Sensor needs to stabilize
Used sensor: wait 60 seconds.
New sensor: wait 5 minutes.
Low battery alarm
Refer to
Battery Cautions
,
Replacing the Alkaline Batteries
,
Replacing the
Lithium Battery Pack
.
Sensor alarm
Refer to
Replacing a Sensor or Sensor Filter
.
Pump alarm
If the sampling hose is attached, determine if it is obstructed. If not, clean
or replace the pump filter. If the pump alarm persists, refer to the “Pump
Operation” section in Troubleshooting.
The startup self-test fails.
General fault
Ensure that the sensors and battery pack are installed correctly and then
reactivate the detector.
If the fault persists, record the error message and contact
BW Technologies
by Honeywell
.
Summary of Contents for GasAlertMicro 5IR
