TITLE
Model
DOCUMENT NO.
PAGE
CN70 Service Work Instructions
CN70A,CN70E
SWICN70-000
Page
35
of
45
OPERATION:
Camera
The camera is located on the scan bracket assembly. To service the camera you will need to remove the scan bracket
assembly.
Tools Required
Description
Part Number
T10 Torx driver
T7 Torx driver
Phillips screwdriver with #1 tip
Parts Required
Item Part Number
Description
Qty
1
715-614-001
Camera Module 5MP
1
1
715-614S-002
Camera,5MP Elastic Adh SubAssy (current refresh program production)
1
2
655-226-001
Shield
1
3
800-577-002
SCREW,M1.4x0.45x3mm,TAPPING,PH PD,RoHS
4
4
813-169-001
Grounding gasket
1
5
655-340-001
Foam pad
1
**
655-252-001
CLIP, CAMERA BLANK
1
6
655-518-001
Camera,Barrier LED Flash
1
** units without a camera but with a WAN radio will have this blank metal piece installed in place of a camera. Units
without a camera and without a WAN radio will have nothing installed in the camera location.
Removal
1. Remove the bottom housing assembly (refer to Bottom Housing operation).
2. Remove the scan bracket assembly (refer to Scan Bracket Assembly operation).
3. Using a #0 Phillips screwdriver remove four screws that secure the camera to the scan bracket assembly.
The camera shield and camera can now be removed. Compress the grounding gasket on the back of the flex cable to
slide the flex through the slot in the scan bracket assembly.
Installation
1. Slide the flex through the slot in the scan bracket assembly.
2. Position the camera and shield into the scan bracket assembly.
3. Using a #0 Phillips screwdriver install 4 screws and secure the camera to the scan bracket assembly with 1.2+/-0.2
in-lbs of torque.
4. Verify that the grounding gasket is still attached to the camera flex as shown in the picture below. If this is a new
camera you will need to install a new grounding gasket (item 4).
1
2
3
5
4
